Inflating your board

My pressure gauge is not working - what do I do?
Your high pressure pump gauge requires quite a bit of back pressure to get the needle ‘off the stop’ – sometimes as much as 5-7psi. Even though you’ve pumpe...
Wed, 27 Oct, 2021 at 2:33 PM
How long does it take to inflate my board?
Your board can take up to 10-15 minutes of continuous pumping to fully inflate. This will vary depending on the pace you pump. It is a good idea to begin pu...
Wed, 27 Oct, 2021 at 2:38 PM
Can I keep my board inflated?
Yes, you can keep your board inflated. We do recommend that you fully clean and dry your board and keep it stored out of direct sunlight in a cool dry place...
Wed, 27 Oct, 2021 at 2:43 PM
What is the recommended PSI?
All of our boards have a recommended pressure of between 15 and 17psi. 
Mon, 1 Nov, 2021 at 2:24 PM
How do I inflate my board?
Make sure the valve is in the UP position (press down the centre pin of the valve and turn 90 degrees either direction to achieve this) On the end of the ...
Fri, 12 Nov, 2021 at 3:34 PM